Materials needed:
- Loop ----------------------------------------- x4
- Screw and Nut ------------------------------------ x8 each
- Rubber band ---------------------------------- x2
- End nut -------------------------------------- x1
- Ball bearing ---------------------------------- x1
- Aluminium rod (60cm) -------------------------- x1
- Thin wire ---------------------------------------- x1 roll
- Fish Tank/Storage box ----------------------- x1
- Acrylic Sheet (30cm x 30cm) ----------------- x1
- Edible Bubble solution ---------------------------- x1 bottle
--------------------------------------------------------------------------------------------
Instructions:
- Use the template given, cut acrylic sheet using a lazer machine.
- Using a heat gun, twist the blades to an angle.
- Secure the ball bearing in the middle and leave the fan aside.
- Coil the thin wire around the loop and secure it onto the fan using screws and nuts.
- Create a 5cm bend on the aluminium rod.
- Place 1 rubber band onto the bend, then the fan, then another rubber band.
- After that, use a hot glue gun and secure the end nut to the bend.
- Once the wind mill is done, secure it to the fish tank.
- Pour edible bubble solution into the tank, ensure that the loop is submerge into it.
- Last but not least, place it at a windy place and eat the bubbles. :)
--------------------------------------------------------------------------------------------
Template:
